RF INSTALLATIONS

This includes installation of feeder cables, Panel Antenna, TMA( Tower Mounted Amplifiers). the feeder are installed by cutting the required number and length of the feeder and the opening mouth are covered to prevent moisture and dirt from entering, one end of the feeder is now terminated using feeder connector and later run and attached to the tower ladder with the aid of Clamps to the desired height from which it is connected to the Antenna with Jumper cable either directly or indirectly through the TMA to boost the Signal Level .

ANTENNA AND TMA INSTALLATIONS

The last Out door installation on Rf is antenna and TMA , there are 2 major types of antenna either a V- pole single band antenna which is usually for Tx or Rx while the other type is Cross pole X pole which is dual band that is, it has both the Tx and Rx at the same time that is -45 and +45 port in any case we install the antenna with excellent performance following correct Azimuth and tilting and reliable sealing to prevent water or moisture entering.

RBS INSTALLATIONS

The Radio Base Station (RBS) handles the radio interface to the mobile station. One RBS can serve 1,2 or 3 Cell. A group of RBSs is controlled by one BSC. RBS implementation is transceiver-oriented, ensuring good redundancy features. This means that as little as possible of the equipment is common to several transceivers.

MICROWAVE IMPLEMENTATION

A stable and reliable transport network is essential for good network operation, Microwave radios provide an efficient and rapid way of developing wide coverage telecommunication networks. The use of Mini-Link is particularly suited for cellular application because of its flexibility concerning capacities configuration and space required. It also offers fast deployment in all project phases, from planning to commissioning.